In order to adapt to different lift high-speed pump speed

2021-05-02

Donghu Pumping Station of Shenzhen adopts 4 speed control units and 2 speed control units, and designed water supply capacity of 1.08 million m3 / d. The speed governing system of this pumping station is briefly introduced, the energy saving effect, existing problems and its maintenance and management methods are introduced. Text 0 Overview ?? Shenzhen City Water (Group) Co., Ltd. East Lake Pump Station is located below the reservoir in Shenzhen, is a former pumping station. Owing to the serious water shortage in Shenzhen, the tap water source came from neighboring Dongguan via 83km and was upgraded to Shenzhen Reservoir via Level 8 and then to Shenzhen and Hong Kong. The daily water supply in Shenzhen Special Economic Zone is more than 1 million m3, mainly provided by Donghu Pumping Station. Due to the concentration of rainfall in Shenzhen in recent years, resulting in drought and water shortage for most of the time, Donghu Pumping Station not only supplies raw water from various waterworks in the SAR but also supplies water to Baoan District. Before the Dongshen Water Supply Project overhaul, Reservoir water storage for use during maintenance. Therefore, the characteristics of Donghu pumping station are as follows: the water supply volume is large, and the daily water supply volume is more than 1 million m3; the head of water supply varies greatly during the year, the center elevation of the pumping station is 6m, the elevation of the water distribution well is 20-40m, The elevation is 58m, the water level of Shenzhen reservoir water level elevation varies between 16 ~ 27m. Therefore, it is very necessary for the pumping station to adopt a Speed Governor to adapt to different changes in head and water volume. East Lake pumping station designed by the Beijing Municipal Engineering Design and Research Institute, started in early 1992, completed trial operation by the end of 1993, in May 1994 formally run. The pump room is equipped with 6 horizontal centrifugal pumps, single power is 1 600kW, 4 with 2 spares, of which 4 units selected Swedish ABB products, matching pumps used in Japan KUBOTA products. 2 units as a backup speed fixed unit for the Xiangtan motor and Changsha pump. Pump design water supply capacity of 1.08 million m3 / d, has now basically reached full capacity. 1 speed control system features East Lake pumping station speed governor used for the cascade speed control system, ABB's 90 new products, technically advanced. The main control part of microcomputer control, cascade speed control system function settings, parameter settings, operating data display and so on are all concentrated in an operating screen, with flexible and intuitive features. In the monitoring and protection of the motor, it also uses a microcomputer-based integrated protection device, which replaced a large number of intermediate relays and improve system integration and reliability. When the unit is running, the micro-computer dynamically detects various parameters of the cross-talk system and can display it in the form of bar graph or numerical value on the display screen. The operator can check the desired parameters at any time by pressing the key. When the equipment breaks down, the system will automatically record the breakdown information, the breakdown content appears on the operation screen in the form of the text, may call at any time, in order to help diagnose the breakdown reason. The control system also integrates a six-channel recorder, can be arbitrarily selected six parameters associated with it, in the form of curves on the LCD screen real-time display of parameter changes. When the equipment fails, the channel recorder can lock the information before and after the failure occurred, and study the reason of the failure by studying the parameter changes. In the design of rectifier bridge and inverter bridge, ABB uses a controllable rectifier bridge, through the rectifier bridge and inverter bridge SCR timing control, to ensure that the inverter bridge will not be short-circuit through the rectifier bridge. Eliminating the possible circulation between the rectifier bridge and the inverter bridge. The DC smoothing reactor commonly used between the two bridges can also be omitted, thus saving costs, reducing installation space and power consumption of the smoothing reactor , Inverter bridge and inverter transformer reduce the loss, the overall efficiency increase, because there is no reactor, the entire cascade speed control system on the power supply fluctuations will not be too sensitive. This system has three modes of operation: CASCADE, BYPASS, SCRO. Three kinds of working modes not only relate to each other, but also different, the three can be smoothly switched. When the serial speed is running, when the speed reaches the lowest serial speed, the serial input is put into the system. The motor speed can be adjusted between the highest speed and the lowest speed. In bypass operation, the motor starts with a starting resistance, then the starting resistance is shorted, Full speed operation; rotor short-circuit operation, between series and bypass between the way, within the speed range, and the same series control mode, when the given value is greater than the maximum speed range, automatically into the bypass operation, When the given value is within the speed regulation range, the series control system is automatically put into operation again, and the unit operates in the series modulation mode. 2 speed energy-saving effect East Lake Pump Station from May 1994 formally put into operation has been more than 5 years, during the working methods have undergone great changes, pumping unit design lift is 37m, just started running in 1994, speed The unit is being debugged, mainly running fixed speed unit. After commissioning of speed regulating unit, the main running speed governor unit. Initially, due to the small amount of water supply, elevation of the water point low, so the crew work in the low head, high flow conditions, this time low efficiency unit, away from the high-efficiency area. With the gradual increase of water supply, the pressure of water supply gradually increased, and the working lift of the unit increased from less than 20m to 33m, and the unit efficiency was greatly increased. Before December 1995, the working pressure of generating units was basically the same. From the original statements, we sorted out the power consumption per thousand cubic meters of water at speed regulation and constant speed work, which are listed in Table 1. From January 1996 to September 1998 Between, the work style changes a lot. Since October 1998, the working condition has been relatively stable. We select the data from November 1998 to June 1999 as Table 2. In Table 1, since the speed regulating unit and the constant speed unit work at the same time, we do not distinguish between single unit water supply unit consumption, but only classify the speed regulating unit and the fixed speed unit. In Table 2, 1 # ~ 4 # units are speed control units and 5 # and 6 # units are speed units. Among them, 1 # and 2 # work in the speed control mode; 3 # and 4 # work in speed control mode at some time, and work in constant speed mode at some time. Therefore, in dealing with Table 2, we mainly contrast the relationship between speed and speed. For Table 1, the data is processed as follows: ?? Energy Saving Rate = (89.02-52.82) /89.02×100%=40.67% ?? For Table 2, the data is processed as follows: ?? The weighted average of 1 # and 2 # units The average power consumption of 5 # and 6 # units is 117.58 (kW · h / 103m3); the energy saving rate is (117.58-93.91) /117.58×100%= 25.21%. ?? Through the above data analysis shows that when the water supply head is low, the unit is not working in the high-efficiency zone, by adjusting the motor speed, you can change the operating point, so that unit efficiency, and thus energy-saving effect is very significant, energy-saving rate as high as 40% ; When the lift is raised, the unit efficiency is obviously improved, and the basic work of the unit is in the high-efficiency area, and the energy-saving rate still reaches 25%. Visible, energy-saving effect of speed control unit is very good. 3 System Maintenance Experiences and Problems During the construction of the East Lake Pump Station, it suffered a flood of 100-year-olds and some of its equipment was once flooded. After the system was put into operation, many problems occurred, some were technical problems, some were equipment problems, and some were left over from incomplete flooding treatment. In the past five years, the equipment has basically operated normally and the problems that have occurred have been solved one by one. Through five years of operation and maintenance, we feel that to manage this system, we must first have a strong technical maintenance team. September 1995, 2 # # unit failure, equipment operation sometimes normal, sometimes tripping, and burning control insurance. A single test each component, are normal; cast DC, found + 5V power is not normal. After analysis of the drawings, paragraph by paragraph test, and finally found a more hidden place, a piece of metal debris ride in the power board between the two feet, when off, clear the metal debris after the device is operating normally. In the equipment operation, we found that the system still has some problems: (1) The system is more sensitive to lightning strikes, especially for some electronic components. Shenzhen is located in Dorei area, where the pump station is exactly the lightning strike area in Shenzhen. August 1995, there was a lightning strike, Unit 3 trip, fuzzy control speed control screen, restore the DC and reset after normal. (2) series system power factor is relatively low, according to our original record, the lowest when only 0.65. Therefore, it is necessary to install local compensation devices and harmonic absorption devices, but the harmonic absorption devices are prone to failure. Under the action of harmonics, the low-voltage transformers often burn-in phenomenon. (3) Thyristor will generate heat when working, so that the temperature inside the device is very high. In summer, the continuous high temperature in Shenzhen caused the temperature in the control cabinet to reach as high as 41 ° C, which is unfavorable for the work of the equipment. Therefore, the ventilation problem of the equipment is very important. Now, we will be part of the surrounding glass removed, the basic guarantee of work, but in the temperature is too high, have to be resolved through other means. In order to make the system run normally, in addition to cultivating an excellent team technically, we must also have a set of effective methods in management and intensify the management. (1) To establish a file for each device, and use computer management, the device parameters of various regular input, as historical data, for analysis and comparison purposes. Every time the equipment for maintenance, maintenance, replacement of components, timely reflection in the file, be prepared. (2) Regularly clean the carbon brush, vacuum cleaner to absorb toner, check the carbon brush wear and pressure are balanced, measuring the carbon brush length, when the length is less than the specified value, to be replaced in time. (3) regular cleaning of the SCR cabinet filter, filter clogging may cause SCR components poor heat, resulting in SCR burned. ABB string transfer system in my station more than five years of operation, basically normal. System has a certain advanced technology, operation and management more convenient, and its energy-saving effect is more obvious, to achieve the desired goal. ?

We carry high quality Speed Governor as below

Passenger Elevator Speed Governors, Panoramic Elevator Speed Governors, Home Elevator Speed Governors, Hospital Bed Elevator Speed Governors, Freight Elevator Speed Governors, Car Elevator Speed Governors, Service Elevator Speed Governors, Goods Elevator Speed Governors, MRL Elevator Speed Governors

for all major elevator and escalator brands as below

OTIS Elevators, ThyssenKrupp Elevators, Schindler Elevators, KONE Elevators, Mitsubishi Elevators, Fujitec Elevators, Hitachi Elevators, Toshiba Elevators, Fuji Elevators, Express Elevators, Sigma Elevators, LG Elevators, Hyundai Elevators, BLT Elevators, CANNY Elevators, SJEC Elevators, KOYO Elevators, IFE Elevators, Thyssen Elevators, GiantKONE Elevators, XJ Schindler Elevators, Xizi OTIS Elevators, Shanghai Mitsubishi Elevators, GUANGRI Elevators

OTIS Elevator Overspeed Governor, Thyssen Elevator Overspeed Governor, KONE Elevator Overspeed Governor, GiantKONE Elevator Overspeed Governor, ThyssenKrupp Elevator Overspeed Governor, Schindler Elevator Overspeed Governor, XJ Schindler Elevator Overspeed Governor, Xizi OTIS Elevator Overspeed Governor, Mitsubishi Elevator Overspeed Governor, Shanghai Mitsubishi Elevator Overspeed Governor, Fujitec Elevator Overspeed Governor, Hitachi Elevator Overspeed Governor, Toshiba Elevator Overspeed Governor, Hyundai Elevator Overspeed Governor, LG Elevator Overspeed Governor, Sigma Elevator Overspeed Governor, Express Elevator Overspeed Governor, GUANGRI Elevator Overspeed Governor, FUJI Elevator Overspeed Governor, BLT Elevator Overspeed Governor, CANNY Elevator Overspeed Governor, SJEC Elevator Overspeed Governor, KOYO Elevator Overspeed Governor, IFE Elevator Overspeed Governor

We also offer multinational corporation with different overspeed governor as below trip speed governor, bail type governor, horizontal shaft governor, pull through governor, centrifugal governor, centrifugal type governor, flyball governor, tail rope governor, displacement governor, displacement type governor, governor safety fence, governor overspeed switch, governor tripping speed, governor catch, governor bracket,

governor rope grip jaw, governor switch, governor rope, governor cable, rope retaining guard, governor sheave, governor rope tension sheave, governor tension sheave, governor rope releasing carrier, governor tension weights, wedge type governor, disk type speed governor, escalator overspeed governor, Elevator Speed Governor, Elevator Overspeed Governor, Elevator Governor

 

 

 

 

 

 

 

 

 

Elevator Speed Governor, Elevator Overspeed Governor, Over Speed Control Governor, Passenger Elevator Overspeed Governor, Elevator Governors
STAR Imp & Exp Co., Ltd. http://www.zjsmartcommercialescalators.com